Description
Replacement Piston Head complete with Piston Rings, Gudgeon Pin and Circlips. Made from toughened cast Aluminium.
Generator Guru says:
Be sure to investigate the reason you are changing the piston. This could be due to:
- The valve clearances being out. Inspect the valves for damage and replace if necessary. Contact us if you need valve clearance measurements.
- Damage to the Con Rod or the Con Rod Slip Rings. Inspect for damage and replace parts if necessary.
- Low oil preventing sufficient lubrication to the piston and rings. If the engine did not shut down when oil was low then replace the Oil Sensor.
If there is damage to the Cylinder Block, such as deep scrapes from the damaged piston, you will also need to replace this. (Please contact us if you require a new Cylinder Block and cannot find it on your equipment listing.)
Hint: When replacing the piston, first warm it in your hands, or let it sit in a warm area. This will allow you to insert it into the cylinder head much easier.
*COMPATIBLE PART