Description
Replacement Piston Head complete with Piston Rings, Gudgeon Pin and Circlips. Made from toughened cast Aluminium.
Generator Guru says:
Be sure to investigate the reason you are changing the piston. This could be due to:
- The valve clearances being out. Inspect the valves for damage and replace if necessary. (If you need the Valve settings please see "Cylinder Head Parts" as the settings are listed here for each unit.)
- Damage to the Con Rod. Inspect for damage and replace parts if necessary.
- Low oil preventing sufficient lubrication to the piston and rings. If the engine did not shut down when oil was low then replace the Oil Sensor CDI, (if applicable for your unit.)
If there is damage to the Cylinder Block, such as deep scrapes from the damaged piston, you will also need to replace this. (Please contact us if you require a new Cylinder Block and cannot find it on your equipment listing.)
Hint: When replacing the piston, first warm it in your hands, or let it sit in a warm area. This will allow you to insert it into the cylinder head much easier.
There are a few different sizes for this model. Please state bore size.
*Compatible part