Description
Replacement Cylinder Head Prebuilt with Valves and Rockers, cast from toughened aluminium. *Comes with Free Head Gasket*
Generator Guru says;
Complete Cylinder Head, comes pre-installed with; Valves and their Springs, Seals, Retainers and Rotator Cap; Rocker Studs and Pivots and the Push Rod Guide Plate.
Easy and quick to install. Saves a great deal of time as the Valves do not need to be grinded and the Springs do not need to be compressed to locate the Retainers.
Simply, locate the Head Gasket, slide the new Cylinder Head down into place, tighten the bolts down, insert the Push Rods and set the Valve clearances. That is all there is to it!
Please see below for the recommended Torque values and Valve Clearances
- Cylinder Head Bolts: 24Nm or 17.7Lbft
You need to adjust your valve lash clearances to:
- Intake: 0.015" (0.4mm)
- Exhaust: 0.015" (0.4mm)
*compatible part
