Male fixing - screws into the tank (fuel tank thread inside tank) then seals the O-Ring by tightening the secondary nut. Sometimes this can get broken off in the tank (see advice below). The Male also has a small nut at the top that is thinner than the 2 fixings on the on/off switch plate. Click on option above to see picture.
Female fixing - screws onto the tank (fuel tank thread protrudes from tank) using the large nut on the petcock to attach and seal the O-Ring. The female version had a large wide nut at the top, when undone, shows the tank has threads protruding from the tank. (This can be seen on the home screen of our video below.) Click on option above to see picture.
If you are not sure, get in touch!
Generator Guru says:
This are a common item to need replacing due to the exposed location of the part. We often hear that something has knocked it, resulting in a leaky, or broken Fuel Tap Petcock.
If you have had a Male Petcock break off with the stem still in the tank, use a pair of needle nose pliers and insert into the stem. Open the pliers up, and unscrew. It should release without damaging the tank. Be careful not to damage the thread on the tank, or you will need to replace the whole tank.
*compatible part
worked well, good price
Just what I needed. For perfect works perfect.
Thank you
Very good
Right valve. Worked 1st time.
Great service exact an easy replacement
The part fit fine and works great! The shipping was fast and the rates were very reasonable. Will buy again!
Good price and instructions.
The petcock is a good replacement for the original. Easy to install and worked right off the bat. The delivery was quick.
